nesdev.org

ah I found the problem I tried jumpering the write pin to ground instead of +5 looks like hooking pin 31 to VCC makes it work I doubt this will work with larger flash sizes though since hole 2 of the program is A18

fortunately not much uses 4 megabit roms.

actually I have PMC flash chips the exact one is this
http://www.datasheetarchive.com/Pm29F00 ... sheet.html

I tried to match everything up based on the nes rom pinouts and got a partally working program with half the graphics ok and the other scrambled.

I successfully put blade buster on a TSROM board. I don't think it saves anything and those TKROM are usually just slightly harder to find cheap ones.

my programmer sucks.

I cannot reliably program eproms only flash.. and there is no way to add a power supply it's USB ONLY.

what differences would there be for a TSROM when using a 29f002t ?

hmmm I'm having trouble I have only replaced the PRG so far but I should get the game to boot with corrupt graphics at least with the original CHR chip in place right? I've tried just a direct to the board without rewire (like some konami boards) and got just a purple screen tried wiring it as a TKr...

I want to put patched translated roms in my Just Breed famicom cart but I'm not sure how to wire the cart to work with eproms(actually I have a single 27c040 and about a dozen pm29f002's which don't seem to work when wired like a 27c020)