nesdev.org

Ah, my bad. It doesn't have a label along with another game which I believe is NHL 93 and so I got them mixed up.

As far as I can tell, Stanley Cup is no good. It has no battery backup and no decoder chip. I can tell you that there is a version of Super Mario World that is compatible with 36 Pin MaskRoms: http://www.snescentral.com/pcbboards.ph ... VC-1A1M-01

I'm getting "Error at 0x000000 chip = 67 Buffer = 0xXX"

Anyone help with this?

Thanks.

I have a quick question about this mod, do you just have to burn the CIC Key hex fil to a 12F629 and solder it in a shown above?

Also, Bytestorn, how did it go, did it work?

Thanks.

Does that require any rewiring or does it just slot in?

Ah, I got confused, the cart I was thinking of is only 32 pins.

If I buy an NTSC cart can I replace the CIC chip with a 74ls161 and have it work on a PAL system or do you have to write something to the 74ls161 for it to work?

It turns out you just burn 4mb/2mb and solder it in so that's good. If a game has supported ROM sizes up to 16mbit does that mean I can't use the 29F032 because it's a 32mbit chip or does it just mean it won't work with 32mbit/4mb games?

Will these work for these repros: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=251028795096&fromMakeTrack=true&ssPageName=VIP:watchlink:top:en ? As for programing the 29l3211s you can buy them for $2.5 each from BuyICNow and they can program them for you so you don't have to bother...

I'd be interested to know how you get on. Some guy has done this already and his repros are shown here:

http://www.digitpress.com/forum/showthr ... ost1900528

Will using a Japanese ToP as a donor work since it'll already be configured correctly to run off two roms?

http://www.snescentral.com/pcbboards.ph ... VC-LJ3M-01 - Snescentral page that details the board pretty well although I don't understand any of it :p.

Thanks a lot, you've been a great help. I've just got one more question; How do you go about doing 6mbit roms this way? Do you daisychain a second board to the first like you would if you make a reproduction the EPROM way?

Thanks again.

Thanks. So is it literally just solder the 29f032 in and the solder the type 3 into the board, no rewiring needed?

I've got another question; if a rom is say 2.5mb/3mb can I just burn that to the chip and it'll work fine or will I need to make therom 4mb or do some rewiring?

Thanks again .

Thanks, That's good to hear. Do you know if any of the DIP36 to TSOP40 adapters on buyicnow can be used to make a SNES Repro?

I'm finding it difficult to find slower chips for a decent price and so was wondering if 90ns is too fast? Also, are the TSOP 40 to DIP36 adapters on buyicnow compatible with SNES reproductions? Finally, what TSOP adapter should I get? I have a similar one to this: http://www.bakersfieldads.net/East...