nesdev.org

First off I want to say it is very hard to say where your wires are going on the chr pin/hole 24. Anyhow that wire you are using looks to be aluminum copper clad (junk wire). I could be wrong but I see no copper in the blue wire that is wide open. Some wire from china is made like crap. Just becaus...

FrankWDoom wrote:What did you do with pin 1 on the prg chip? It should be bent up at the very least, even if you aren't rerouting pin 30.

I cut it

So i wired up the board according to the # and left out pin 30 to hole 1 I connected pin 24 to hole 16 along with pin 16 since its GND on the chip and the board. I ended up breaking a few pins but managed to get them connected anyway. The soldering is godawful but i checked the connections and there...

Thanks for clearing that up!
Im gonna try go by the pin # and see where it gets me, in a worse case scenario i guess i could post a picture of the outcome to get some experienced eyes on it.

Hi, i got a quick question i hope someone can help me with. I just flashed 2 x Atmel AT27C010 (datasheet here http://www.atmel.com/images/doc0321.pdf ) with chr and prg rom data and now that im looking to solder the roms onto my doner board i got kinda confused. the EEprom conversion list for SLROM ...