Problem while switching on genesis

[TmEE]

Reset on MD is edge sensitive not level sensitive, wiring it shut will not generate any infinite resets.

Those switches the clone has go bust very often. I am actually tempted to trade real MD2 for that clone... I like me some superclones

[lidnariq]

4a) If only #1, use a multimeter or a wire to short A to B once a game is running
4b) If only #2, cut away or desolder and remove the button, then do the same test as above (on the holes the button was in)

what if I don't have a multimeter ...should I try 4a and 4b?

Reset on MD is edge sensitive not level sensitive, wiring it shut will not generate any infinite resets.

Those switches the clone has go bust very often.

In light of what TmEE says ... go for it. As long as you're careful to not damage the PCB.
Or maybe see if he's interested in following through on exchanging a real MD for your clone.

and another question do u think that the adapter might be the cause of the button problem?

You may as well wait until you have a large enough power adapter: it will be a lot easier to test whether the reset button is working if you don't have to wait for things to warm up.

(but I doubt that it's the cause)

[ouso1999]

go for it. As long as you're careful to not damage the PCB.

how would the PCB be damaged?do u mean while soldering?

[lidnariq]

how would the PCB be damaged?do u mean while soldering?

Yes. Things done while desoldering, including heat and moving things, can cause layers on the PCB to peel off. Thus "be careful"