Hi, I was into make a micromages cart (also another with second quest), so splitted the ROM with FamiROM and burned 2764 for chr and 27256 for prg.
Then, soldered the 2764 and 27256 in the HVC-VROM-01 board but it didnt work, so opened another baseball game and the board was dip-24 for the chr (HVC-SROM-03).
Comparing to a NROM, they differ, is a conversion posible?
Here is no mention to those boards: https://www.nesdev.org/NES%20EPROM%20Conversions.txt
And there is a pinout for chr in the SROM board: https://www.nesdev.org/wiki/Mask_ROM_pinout#Variants
HVC-VROM and SROM board for micromages
Moderators: B00daW, Moderators
Forum rules
1. NO BLATANT PIRACY. This includes reproducing homebrew less than 10 years old, with the exception of free software.
2. No advertising your reproductions, with the exception of free software.
3. Be nice. See RFC 1855 if you aren't sure what this means.
1. NO BLATANT PIRACY. This includes reproducing homebrew less than 10 years old, with the exception of free software.
2. No advertising your reproductions, with the exception of free software.
3. Be nice. See RFC 1855 if you aren't sure what this means.
-
- Posts: 15
- Joined: Tue Oct 06, 2020 5:51 pm
HVC-VROM and SROM board for micromages
Last edited by crissaegrim87 on Fri Jan 20, 2023 5:45 am, edited 1 time in total.
Re: HVC-VROM board unknown
VROM is just NROM without the nametable configuration solder pads.
SROM is as described.
Both have a perfectly normal 28-pin pinout for the PRG ROM.
If you're having problems, it's not due to needing to do any patches - there's something else going wrong.
SROM is as described.
Both have a perfectly normal 28-pin pinout for the PRG ROM.
If you're having problems, it's not due to needing to do any patches - there's something else going wrong.
-
- Posts: 15
- Joined: Tue Oct 06, 2020 5:51 pm
Re: HVC-VROM board unknown
Well, did a lot of testing in these boards, comparing to a proper NROM-256 of super mario bros. And guess what? pad 35 in VROM and SROM arent connected to A14 (pin 27 of prg eprom 27256). The track is missing!. And mirroring is hardwired (pad 18 is routed to pin 23 of chr eprom 2764). To anyone struggling with this, just lift pin 27 of prg and wire it to pad 35. The game is running now, very glitchy, but that is another story!
-
- Posts: 15
- Joined: Tue Oct 06, 2020 5:51 pm
Re: HVC-VROM board unknown
The game is running fine now, but I replaced the chr eprom due to oxidized teminals not stickig to solder