nesdev.org

Anyone got the instructions for the EXP0 (powerpak flash write enable) CopyNES mod for the parallel version? Bunnyboy's site only has the instructions for the USB version where there's a pin on the board for it. I can't find it on Kev's site anymore.

i'm not sure but I THINK it was CN4?

It should be somewhere in all of this:

http://kevtris.org/Projects/copynes/assembly.html

If not, try e-mailing him. RetroUSB never sold the original version, as i recall, and probably doesn't have this information. I'll check to see if i do or can find it,but I suggest emailing Kevtris when you can to ask if it isn't in the assembly guide.

I found it and I thought I was right. it was the through hole marked CN4, otherwise its the same as the usb version obviously.

I thought about opening mine to check.

http://www.kaiserland77.com/articulos/A ... rflash.htm

peppers wrote:I found it and I thought I was right. it was the through hole marked CN4, otherwise its the same as the usb version obviously.

I thought about opening mine to check.

http://www.kaiserland77.com/articulos/A ... rflash.htm

Ah that looks good thanks. Thanks to babelfish for the translation, too.