Need a source for am29f032b

mysteriousity · Post by **mysteriousity** » Thu Jan 05, 2012 11:28 am

Hi guys,

I need a source for some am29f032b chips and was wondering if you guys could point me out some.

Thanks!

MottZilla · Post by **MottZilla** » Thu Jan 05, 2012 12:13 pm

I don't think these chips are manufactured anymore are they?

Tormenter · Post by **Tormenter** » Thu Jan 05, 2012 12:22 pm

MottZilla wrote:I don't think these chips are manufactured anymore are they?

nope

infiniteneslives · Post by **infiniteneslives** » Thu Jan 05, 2012 2:55 pm

http://www.buyicnow.com/fincat.php?cat=566

used is better than nothing

Hias · Post by **Hias** » Thu Jan 05, 2012 4:43 pm

infiniteneslives wrote:http://www.buyicnow.com/fincat.php?cat=566

used is better than nothing

Nooo now he will be out of stock soon again

Otherwise eBay, a bit more expensive, but always in stock.

rkrenicki · Post by **rkrenicki** » Thu Jan 05, 2012 5:21 pm

He does not have any up right now, but this guy has pretty good deals on these.

http://www.ebay.com/itm/350508401769

Tormenter · Post by **Tormenter** » Thu Jan 05, 2012 5:53 pm

rkrenicki wrote:He does not have any up right now, but this guy has pretty good deals on these.

http://www.ebay.com/itm/350508401769

Ive ordered there before. Usually the legs are bent, and many times ive broken the legs off trying to straighten them.

rkrenicki · Post by **rkrenicki** » Fri Jan 06, 2012 8:35 am

Ive ordered three sets for a total of 36 chips, and I have only had two chips with bent leads, both of which I was able to straighten without a problem.

dranore · Post by **dranore** » Sun Jan 08, 2012 4:27 am

I ordered 4 of the pre-desoldered chips from BuyICNow.

Ziggy587 · Post by **Ziggy587** » Sun Jan 08, 2012 2:14 pm

Be careful when ordering them used. Make sure the seller has a good return policy. I've gotten a few from eBay with bent legs, and I also have had one or two chips that legs broke off of when trying to straighten them. I ordered some from BuyICnow before. The legs weren't bent, but I had to clean some bits of solder off of them.