Page 1 of 1

Need a source for am29f032b

Posted: Thu Jan 05, 2012 11:28 am
by mysteriousity
Hi guys,

I need a source for some am29f032b chips and was wondering if you guys could point me out some.

Thanks!

Posted: Thu Jan 05, 2012 12:13 pm
by MottZilla
I don't think these chips are manufactured anymore are they?

Posted: Thu Jan 05, 2012 12:22 pm
by Tormenter
MottZilla wrote:I don't think these chips are manufactured anymore are they?
nope

Posted: Thu Jan 05, 2012 2:55 pm
by infiniteneslives
http://www.buyicnow.com/fincat.php?cat=566

used is better than nothing

Posted: Thu Jan 05, 2012 4:43 pm
by Hias
infiniteneslives wrote:http://www.buyicnow.com/fincat.php?cat=566

used is better than nothing
Nooo now he will be out of stock soon again :P

Otherwise eBay, a bit more expensive, but always in stock.

Posted: Thu Jan 05, 2012 5:21 pm
by rkrenicki
He does not have any up right now, but this guy has pretty good deals on these.

http://www.ebay.com/itm/350508401769

Posted: Thu Jan 05, 2012 5:53 pm
by Tormenter
rkrenicki wrote:He does not have any up right now, but this guy has pretty good deals on these.

http://www.ebay.com/itm/350508401769
Ive ordered there before. Usually the legs are bent, and many times ive broken the legs off trying to straighten them.

Posted: Fri Jan 06, 2012 8:35 am
by rkrenicki
Ive ordered three sets for a total of 36 chips, and I have only had two chips with bent leads, both of which I was able to straighten without a problem.

Posted: Sun Jan 08, 2012 4:27 am
by dranore
I ordered 4 of the pre-desoldered chips from BuyICNow.

Posted: Sun Jan 08, 2012 2:14 pm
by Ziggy587
Be careful when ordering them used. Make sure the seller has a good return policy. I've gotten a few from eBay with bent legs, and I also have had one or two chips that legs broke off of when trying to straighten them. I ordered some from BuyICnow before. The legs weren't bent, but I had to clean some bits of solder off of them.