Problems with Willem to flash a mounted 29f032B

pichichi010 · Post by **pichichi010** » Sat Jul 14, 2012 2:39 am

I have a mounted 29f032B and I try to read it with my willem burner with the adapter from Retrohacker.info I had burned a mickey game before mounting it and it did not worked on the console.

now I am making a prototype cart for a port game but:

It ID's 0x20 ST Micro and Code 0x55 which is incorrect according to the website.

I can read the info because It read ok, saved the dumped file and played it with the emulator and the Mickey game plays. So this threw me off because the ID was incorrect but still I got to dump the information correctly.

But with I try to verify it gives me error at 0x0000000 chip= 0x20 buffer -x40

When I try to delete It takes about half a second and it says Completed by Check DQ7.

I have a Willem adapter with 32 pin socket I am running A19-21 with the external jumper.

I also Have a GX-4 but I cannot get it to read it, but I guess because I don't have the extra 4 pins soldered in the adapter.

Any suggestions?

SkinnyV · Post by **SkinnyV** » Sat Jul 14, 2012 8:27 am

All you need to know to answer your question are in past thread.

pichichi010 · Post by **pichichi010** » Sat Jul 14, 2012 10:24 am

I've read it back and forward and still getting problems.

I think my willem is outdated.

I will try to sell it and get the Gq-3x